Magnetic ski carrier for 2 pairs of skis / carvers or 2 snowboards

The first snow has barely fallen and we can start.

This is also easily possible with our magnetic ski carrier. Due to the magnetic adhesive surface, the ski rack can be attached to the car roof quickly and easily.
The effective, magnetic contact area per carrier is 30 x 24 cm - this area must be flat on the car roof.
This ski carrier is suitable for 2 pairs of skis / carvers or 2 snowboards.
When you arrive at the ski slope, you can remove the carrier and put it in the trunk for protection.

IMPORTANT! SAFETY INSTRUCTIONS AND HANDLING

• The roof surface must be free of dirt, snow and ice in the area of the parking space.
  The contact surface of the magnetic disk must also be clean, otherwise - in addition to insufficient safety - there is a risk of paint damage.
  
  
• The magnetic plates must be placed on the roof that is as flat as possible.
  It is important to ensure that the entire surface of the magnetic plate rests firmly on the vehicle roof.
  Please make sure to check and, if necessary, press on the magnetic plate!
  
  
• The distance between the front and rear magnetic plates must be determined in such a way that when the binding hits the rear carrier, it is not possible for the skis to tip out on the front carrier
  (As a rule, this is the case with a distance between the grippers of approx. 70 cm).
  
  
• The skis must be loaded with the tips pointing backwards.
  
  
• Special attention is required when using sunroofs!
  For vehicles with a steel sliding roof, it is essential to ensure that the magnetic plates lie completely on a closed sheet metal surface!
  Either completely on the movable sliding roof, or completely on the rest of the roof area - but never over the edge of the sliding roof!
  Do not open the sunroof when the ski racks are on!
  
  
• The handle on the outer edge of the magnetic plate is used for easier removal from the vehicle roof.
  
  
• In the event of shock loads (falling on the floor, etc.), the plates may bend or the permanent magnet material may break.
  
  
• ATTENTION! The necessary safety when driving is only guaranteed if the magnetic plates are perfectly flat and complete.
  
  
• The carrier must not be used on vehicle roofs that have been repaired with layers of tin or filler due to accidental damage, for example.
  
  
• IMPORTANT! Every roof rack affects the driving behavior of vehicles.
  Our magnetic ski carrier is no exception.
  We therefore urgently recommend not to exceed the recommended speeds for motorways - although our magnetic ski racks have also been tested in the high speed range of 200 km / h.
  
  
• ATTENTION! The magnetic ski carrier must be removed after the holiday!
  
  
• The scope of delivery is always 1 pair.
  Delivery takes place in a suitable box