Magnetic strip self-adhesive L silver, length 62 cm

The attractive, self-adhesive magnetic strip from Forster Home serves as an installation base for our magnetic accessories and/or as a memo board.
Using the strip, you can easily install Forster Home accessories on non-magnetic surfaces - for example on wooden kitchens, tiles or non-magnetic kitchen back walls.
 
The magnetic strip L offers space for a maximum of 2 Forster Home standard accessories and/or can be used with our magnets as a memo board for photos, notes or shopping lists.
 
The strip is equipped with adhesive tape on the back and can therefore be installed easily and simply.
Once attached, the magnetic accessories can now be mounted with just one click and removed or hung up again if necessary.
 
Assembly:
Select the desired location where the strip should be installed. Make sure the surface is smooth, non-porous, clean and free of grease.
If necessary, check the alignment of the strip with a spirit level so that the product hangs straight.
Peel off the protective film from the adhesive strips on the back of the product and press the strip onto the surface in the desired location.
Press the strip firmly along its entire length for 20 seconds until it holds firmly. After 24 hours you can fully load the strip and, if necessary, attach a Forster Home accessory to it.
 
Suitable for practically all magnetic Forster Home Accessories products (with the exception of the coffee capsule holder, multi-purpose cup, knife block, dishcloth holder and sponge holder).
 
A notice:
Due to production reasons, the product may have color irregularities and sanding marks on the back.

• The product conforms to the European RoHS Community legislation

  The product conforms to the European RoHS Community legislation (2002/95/EG - RoHS - Restriction of Hazardous Substances) relating to the use and the employment of certain hazardous substances in electrical and electronic devices.
  No subject to registration under the REACH Regulation.

• Determination of the magnetic force

  The adhesive force of our magnets is determined at room temperature on a polished plate made of steel S235JR (ST37) with a thickness of 10 mm by the vertical withdrawal of the magnet (1kg ~ 10 N). A different value down to -10% compared to the specified value is possible in exceptional cases. In general, the value is exceeded. Please note that for thinner, painted and not absolute plan undergrounds the adhesive force represents only one raction of the specified values.